Crack Para Autocad 2011 64 16
In the process of materials fracture, a very important parameter to study is the cracking rate growth da/dN. This paper proposes an analysis of the cracking rate, in a comparative way, by using four mathematical models:1 - polynomial method, by using successive iterations according to the ASTM E647 standard; 2 - model that uses the Paris formula; 3 - Walker formula method; 4 - NASGRO model or Forman - Newman - Konig equation, abbreviated as FNK model. This model is used in the NASA programs studies. For the tests, CT type specimens were made from stainless steel, V2A class, 10TiNiCr175 mark, and loaded to a variable tensile test axial - eccentrically, with the asymmetry coefficients: R= 0.1, 0.3 and 0.5; at the 213K (-60C) temperature. There are analyzed the cracking rates variations according to the above models, especially through FNK method, highlighting the asymmetry factor variation.
crack para autocad 2011 64 16
In this paper, the authors propose a studying method for the deformation that appears before crack of ductile materials using the Lode parameter determined by the numerical calculation applied on simple models, verified in previous studies. In order to highlight the influence of the Lode parameter, the tests were performed at simple but also at compound tests. The necessity of these studies lies in the fact that the acknowledged models (the use of the integral J, the critical stress intensity factor Kc or the CPCD method) do not fully explain the phenomenon of deformation before breaking the elasto-plastic materials. The tests were imagined under the form of sets. Each set of tests was performed on smooth specimens and on specimens with a notch radius of 0.5, 2, 4 and 10 mm. Also, each set of tests was performed for pure tensile and combined tensile-torque test.
Spine fusions can be performed through different techniques and are used to treat a number of vertebral pathologies. However, there seems to be no consensus regarding which technique of fusion is best suited to treat each distinct spinal disease or group of diseases. To study the effectiveness and complications of the different techniques used for spinal fusion in patients with lumbar spondylosis. Systematic literature review and meta-analysis. Randomized clinical studies comparing the most commonly performed surgical techniques for spine fusion in lumbar-sacral spondylosis, as well as those reporting patient outcome were selected. Identify which technique, if any, presents the best clinical, functional, and radiographic outcome. Systematic literature review and meta-analysis based on scientific articles published and indexed to the following databases: PubMed (1966-2009), Cochrane Collaboration-CENTRAL, EMBASE (1980-2009), and LILACS (1982-2009). The general search strategy focused on the surgical treatment of patients with lumbar-sacral spondylosis. Eight studies met the inclusion criteria and were selected with a total of 1,136 patients. Meta-analysis showed that patients who underwent interbody fusion presented a significantly smaller blood loss (p=.001) and a greater rate of bone fusion (p=.02). Patients submitted to fusion using the posterolateral approach had a significantly shorter operative time (p=.007) and less perioperative complications (p=.03). No statistically significant difference was found for the other studied variables (pain, functional impairment, and return to work). The most commonly used techniques for lumbar spine fusion in patients with spondylosis were interbody fusion and posterolateral approach. Both techniques were comparable in final outcome, but the former presented better rates of fusion and the latter the less complications. Copyright 2011 Elsevier Inc. All rights reserved.